Free Cram & Latest Exams Dumps

NO.75 Exhibit.

Which would explain this issue?

NO.76 You recently added ClearPass as an authentication server to an HPE Aruba Networking Central group.
RADIUS authentication with Local User Roles (LUR) works fine Out the same access points cannot use Downloadable User Roles (DUR).
What should he corrected in this configuration to fa the issue with DUR?

NO.77 A network administrator accesses HPE Aruba Networking Central and notices that visitors consume too much internet bandwidth starving employee traffic when accessing an external service. Therefore, the administrator wants to limit wireless bandwidth to 60 Mops in both directions among all users in the voice rote and no more than 10 Mops in both directions for YouTube traffic. Deep packet inspection, web content classification, and firewall visibility are enabled.
Which configurations are required to accomplish this task? (Select two.)

NO.78 You are tasked with developing a comprehensive, flexible, and survivable zero-trust wired access network using CX 6300 switching and HPE Aruba Networking ClearPass Policy Manager. Match the scenario to the special roles to achieve your objectives.

NO.79 Exhibit.

Which statement is true given the following CLI output from a CX 6300?

NO.80 A customer has interfering devices that are seen over the air. They contact you and ask you to configure RAPIDS to help identify interfering and rogue APs. HPE Aruba Networking Central identifies a rogue AP and displays the connected switch port.
How can HPE Aruba Networking Central identify which switch port the AP is connected to?

NO.81 Anetworkadministrator accesses HPE Aruba Networking Central and notices that visitors consume too much internet bandwidth starving employee traffic when accessing an external service.Therefore,the administrator wants to limitwireless bandwidth to 60 Mops in both directions among all users in the voice rote and no more than 10 Mops in both directions for YouTube traffic. Deep packet inspection, web contentclassification, andfirewall visibility are enabled.
Which configurations are required to accomplish this task? (Select two.)

NO.82 An ACME company employee complained about a recent poor-quality VoIP call while moving around their office environment. HPE Aruba Networking Central reported a fair UCC score for this call while your VoIP engineer reported that their systems reported a MOS of 2.3. The VoIP devices are operating over the 5GHz frequency band.
What are the possible contributing factors? (Select two)

NO.83 Refer to the exhibit.

To which devices has AP-1 established tunnels?

NO.84 The ACME company has an AOS-CX 6200 VSF switch slack with an uplink over subscription ratio of 9.6:1.
They have indicated that their low-priority TCP traffic has been flagged with a DSCP marking coloring them yellow.
Refer to the exhibit.


They are considering adding two more nodes to the stack without adding any additional uplinks due to existing wiring constraints. One of their architects has suggested adding the following configuration:

What would be the impact of applying the acmethreshold profile as shown? (Select two.)

NO.85 A Windows device attempts to connect to an 802.1X network but it is not receiving the correct role. TEAP has been configured asthe only authentication method in ClearPass.The wireless configuration is correct.
Exhibit.

What is me mostlikelycause?

NO.86 Exhibit.

An engineer has applied the above configuration to R1 and R2 However the routers OSPF adjacency never progresses past the “EXSTART-DR” slate as shown below.

Which configuration action on either router will allow R1 and R2 to progress past the “EXSTART/DR” state?

NO.87 Your customer recently decided to build a new wireless network based on AOS-10. The following legacy settings still exist:
* The DHCP server still sends option 60 “ArubaInstantAP” and option 43 including the IP address of the AirWave server in the ZTP VLAN.
* The DNS server has an entry for “aruba-airwave” pointing to the AirWave server.
The customer purchased new AP-655 access points and HPE Aruba Networking Central subscriptions.
Each AP is assigned to the “ACX-Group” in the Device Pre-provisioning section of Central, and the external firewall allows HTTPS traffic between APs and the Internet.
What will happen when the new factory default APs are connected to the customer’s network for the first time?

NO.88 An AOS-10 multi-site deployment has sites with AP-only bridged SSIDs and other sites with APs and gateways operating tunneled SSIDs. Client session state sync errors exist between secure lab environments and public-facing areas at several sites.
What is causing the issues?

NO.89 After onboarding three new AOS 10 gateways using the full-setup methodinto the same Central group, a customer cannot log in to one of the gateways using the HPE Aruba Networking Central remote console due to an incorrect password.

NO.90 Match each Group Based Policy (GBP) rote description to its respective role ID.

NO.91 A BGP routing table contains multiple routes to the same destination prefix.
Referring to the table below which route would be marked with a “>” symbol?

NO.92 Refer to the exhibit.


A customer is reporting that connectivity is failing for some wireless client devices. What is your conclusion based on the capture?

NO.93 A customer has deployed anAOS 10 mobilitygateway cluster consisting of three controllers at a single site The WLAN is configured to tunnel wireless device traffic to the AOS 10 mobilitycluster.The clients areauthorized to use WPA2-Personal.An end-userhas opened a ticket with the helpdesk stating they cannot connect their client device to the network.There are other devices currently associated with the SSID with no issues.

Reviewing the output, what Is the issue?

NO.94 Exhibit.

Which user role will be assigned when a voice client tries to connect for the first time, but the RADIUS server is unavailable?