Free Cram & Latest Exams Dumps

Q22. Inspection and Test plans are developed by referencing:

Q23. When performing a hardness test on a coating which has elastic properties the inspector is likely to likely to observe:

Q24. When completing the Final Inspection report the Inspector should write the report using:

Q25. When observing fabrication defects the NACE Inspector should:

Q26. When performing inspection in accordance with ASTM D 4138 the Inspector will use:

Q27. All of these are advantages of using repair patches EXCEPT

Q28. When performing testing in accordance with ASTM D 2583 the inspector may observe:

Q29. Coating surveys may include which steps?
Select All That Apply:

Q30. You are working as an inspector in a galvanizing plant for the first time.
What are some of the hazards you need to be aware of:

Q31. Inspection and Test Plans are provided to:

Q32. Antifouling coatings are regulated by international treaties.

Q33. You are the NACE Coating Inspector on a tank lining project and are asked to perform a high voltage holiday test after the coating applicators have completed their final repairs. After meeting all the confined space entry permit you enter the tank and notice a very strong odor of solvent.
Your first course of action should to:

Q34. The standards defining surface cleanliness achieved by centrifugal blast cleaning are:

Q35. Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide if and when a destructive test is required.

Q36. The solvent sensitivity/solvent wipe test (ASTM D4752) is used to determine the cure of

Q37. When measuring the Dry Film Thickness Of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument is the:

Q38. Differences in technique for abrasive blasting concrete versus steel require the operator to:

Q39. Dehumidification is defined as the removal of moisture vapor from the air to

Q40. On pipelines, which coating is identifiable by its distinct colors, usually light blue, green, or grey?

Q41. The primary purpose of Fireproofing coatings are to provide:

Q42. The Inspectors’ goal at the Pre-Job Conference is to: