Free Cram & Latest Exams Dumps

NO.42 Select which of the following are ‘Public IP addresses’:

NO.43 What is necessary for PPPoE client configuration?

NO.44 Using wireless connect-list it’s possible to prioritize connection to one Access Point over another Access Point by changing the order of the entries.

NO.45 What does the passive command provide to dynamic routing protocols?

NO.46 Select minimal set of software packages in RouteOS required to configuring a wireless AP

NO.47 What does a VLAN do?

NO.48 DHCP server is configured on a router’s ether1 interface. IP address 192.168.0.100/24 is assigned to the interface. Possible IP pools, that can be used by this DHCP server, are:

NO.49 During a scan, in order to see all the available wireless frequencies that are supported by the card, the following option must be selected in the wireless card’s “Frequency Mode”:

NO.50 Simple Queue number 0 defines 2M for upload and download for target IP 10.10.0.33.
Simple Queue number 1 defines 4M for upload and download for target IP 10.10.0.33. Client
10.10.0.33 is be able to obtain

NO.51 Which router command allows you to view the entire contents of all access lists?

NO.52 There can be more than one PPPoE server in a single broadcast domain:

NO.53 PPPoE server only works within one Ethernet broadcast domain that it is connected to. If there is a router between server and end-user host, it will not be able to create PPPoE tunnel to that PPPoE server.

NO.54 What configuration is added by /ip Hot-Spot setup command? (select all that apply)

NO.55 Which of the following protocols uses both TCP and UDP?

NO.56 What is term for the hardware coded address found on an interface?

NO.57 You can not use OSPF and RIP routing protocols simultaneously on the RouterOS.

NO.58 Mangle Routing (routing-mark) is possible, by using chains:

NO.59 How long is level 1 (demo) license valid?

NO.60 What is marked by connection-state=established matcher?