Free Cram & Latest Exams Dumps

NEW QUESTION 37
What accurately describes the Simple Network Time Protocol (SNTP)?

NEW QUESTION 38
On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?

NEW QUESTION 39
What is the bandwidth of an RPM for a C9010 Network Director?

NEW QUESTION 40
A network administrator created three VLANs on an Ethernet switch. How many broadcast domains are created by the switch?

NEW QUESTION 41
Which fields are mandatory TLVs in a LLDP PDU frame?

NEW QUESTION 42
Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?

NEW QUESTION 43
Which type of domains are connected by a Layer 2 switch?

NEW QUESTION 44
A Dell EMC Networking N-Series switch is configured on a port channel with LACP using the interfaces Te1/0/1 and Te1/0/2. How is the egress traffic distributed among the interfaces?

NEW QUESTION 45
What are Network Address Translation (NAT) inside global addresses?

NEW QUESTION 46
A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links. The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.
Which corrective action must be taken on the switch infrastructure to correct this issue?

NEW QUESTION 47
The IEEE separates the Data Link and Physical ISO layers into four sub-layers. Based on the exhibit, what is the correct order of these sub-layers; from lowest to highest?

NEW QUESTION 48
Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?

NEW QUESTION 49
Which port type should be used for only VLAN-unaware devices?

NEW QUESTION 50
What is the valid range assigned to a client during a TCP connection?

NEW QUESTION 51
Which BASE-T Ethernet standard specifies a CAT6 cable type?

NEW QUESTION 52
Refer to the exhibit.

Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2. Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?

NEW QUESTION 53
A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients.
Which IPv6 address prefix will the default gateway have on a client?

NEW QUESTION 54
Which formula is used for calculating OSPF interface costs?

NEW QUESTION 55
In IPv4, what is the proper conversion from binary to decimal for the number 11010010?

NEW QUESTION 56
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?

NEW QUESTION 57
On which OSI layers do standard ACL filters operate?

NEW QUESTION 58
You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator has asked you to work on network 192.168.40.0/24.
If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?