Free Cram & Latest Exams Dumps

NEW QUESTION 13
A category 8 cable is terminated into category 6A outlets with category 5e patch cords. What is the maximum supported performance level?

NEW QUESTION 14
What is the bend radius requirement for optical fiber cable when the cable is at rest?

NEW QUESTION 15
Which of the following terms is used to describe mechanical firestop systems?

NEW QUESTION 16
What is the maximum number of work areas that a CP should serve?

NEW QUESTION 17
What is the maximum permissible amount of untwisting for category 5e cable and higher?

NEW QUESTION 18
Which of the following is permissible if the available firestop assembly is NOT capable of properly restoring the necessary fire rating?

NEW QUESTION 19
What is the minimum number of consolidation points that should serve an open office furniture cluster?

NEW QUESTION 20
A third 90-degree bend may be permitted in a conduit run if the run does NOT exceed ______?

NEW QUESTION 21
Which of the following is used to perform continuity and length tests for coaxial cable?

NEW QUESTION 22
Which of the following may provide a demarcation point between the service provider and the customer premises cabling?

NEW QUESTION 23
Fall protection is required whenever a person is exposed to a fall hazard more than ____?

NEW QUESTION 24
Which of the following fire-ratings provides information about smoke leakage?

NEW QUESTION 25
What is the primary purpose of firestopping?

NEW QUESTION 26
If the situation requires, a conduit should be terminated _______ the plywood backboard?

NEW QUESTION 27
Which of the following interconnects the PBB to the SBB?

NEW QUESTION 28
What is the minimum recommended height that should be used when mounting a plywood back board in a telecommunication space?

NEW QUESTION 29
Which type of cabling is installed between a main cross connect and a horizontal cross connect?

NEW QUESTION 30
What is the required physical topology for a SCS?

NEW QUESTION 31
A grey backboard should be used to identify _____ backbone cable?

NEW QUESTION 32
What is the maximum pull force for four-strand optical fiber?

NEW QUESTION 33
Which of the following refers to a set of rules issued by a governmental body at the state level within the US?

NEW QUESTION 34
Which of the following is the primary benefit of using wall-mounted racks and cabinets in place of traditional equipment racks?

NEW QUESTION 35
A third 90-degree bend may be permitted in a conduit run if one of the bends is located within ____ of the cable feed end?

NEW QUESTION 36
Which of the following markings is used for non-conductive optical fiber general-purpose cables?