Free Cram & Latest Exams Dumps

Updated Nov 25, 2022 Verified Pass NSE7_EFW-6.4 Exam in First Attempt Guaranteed

Free NSE7_EFW-6.4 Sample Questions and 100% Cover Real Exam Questions (Updated 124 Questions)

Q41. Refer to the exhibit, which contains the output of a BGP debug command.

Which statement about the exhibit is true?

 The local router has received a total of three BGPprefixes from all peers.

 The local router has not established a TCP session with 100.64.3.1.

 Since the counters were last reset, the 10.200.3.1 peer has never been down.

 The local router BGP state is OpenConfirm with the 10.127.0.75 peer.

Q42. Which real time debug should an administrator enable to troubleshoot RADIUS authentication problems?

 Diagnose debug application radius -1.

 Diagnose debug application fnbamd -1.

 Diagnose authd console -log enable.

 Diagnose radius console -log enable.

Explanation
https://kb.fortinet.com/kb/documentLink.do?externalID=FD32838

Q43. The CLI command set intelligent-mode <enable | disable> controls the IPS engine’s adaptivescanning behavior. Which of the following statements describes IPS adaptive scanning?

 Determines the optimal number of IPS engines required based on system load.

 Downloads signatures on demand from FDS based on scanning requirements.

 Determines when it is secure enough to stop scanning session traffic.

 Choose a matching algorithm based on available memory and the type of inspection being performed.

Explanation
Configuring IPS intelligenceStarting with FortiOS 5.2,intelligent-mode is a new adaptive detection method. This command is enabled the default and it means that the IPS engine will perform adaptive scanning so that, for some traffic, the FortiGate can quickly finish scanning and offload the traffic to NPU orkernel. It is a balanced method which could cover all known exploits. When disabled, the IPS engine scans every single byte.
config ips globalset intelligent-mode {enable|disable}

Q44. Refer to the exhibit, which contains the partial output of a diagnose command.

Based on the output, which two statements are correct? (Choose two.)

 Anti-replay is enabled

 The remote gateway IP is 10.200.4.1.

 DPD is disabled.

 Quick mode selectors are disabled.

Q45. Refer to the exhibits.

Which contain the partial configurations of two VPNs on FortiGate.
An administrator has configured two VPNs for two different user groups. Users who are in the Users-2 group are not able to connect to the VPN. After running a diagnostics command, the administrator discovered that FortiGate is not matching the user-2 VPN for members of the Users-2 group.
Which two changes must administrator make to fix the issue? (Choose two.)

 Use different pre-shared keys on both VPNs

 Enable Mode Config on both VPNs.

 Set up specific peer IDs on both VPNs.

 Change to aggressive mode on both VPNs.

Q46. Which two tasks are automated using the Install Wizard on FortiManager? (Choose two.)

 Installing configuration changes to managed devices

 Importing interface mappings from managed devices

 Adding devices to FortiManager

 Previewing pending configuration changes for managed devices

Q47. An LDAP user cannot authenticate against a FortiGate device. Examine the real time debug output shown in the exhibit when the user attempted the authentication; thenanswer the question below.


Based on the output in the exhibit, what can cause this authentication problem?

 User student is not found in the LDAP server.

 User student is using a wrong password.

 The FortiGate has been configured with thewrong password for the LDAP administrator.

 The FortiGate has been configured with the wrong authentication schema.

Q48. Refer to the exhibit, which contains partial output from an IKE real-time debug.

Based on the debug output, which phase 1 setting is enabled in the configuration of this VPN?

 auto-discovery-shortcut

 auto-discovery-forwarder

 auto-discovery-sender

 auto-discovery-receiver

Reference:
First the Spoke receives SHORTCUT_OFFER, it respondes with sending shortcut-query. AT the end it receives SHORTCUT_REPLY and creates new dynamic tunnel (H2S_0_0).

Q49. Which of the following statements are correct regarding application layer test commands? (Choose two.)

 They are used to filter real-time debugs.

 They display real-time application debugs.

 Some of them display statistics and configuration information about a feature or process.

 Some of them can be used to restart an application.

Application layer test commands don’t display info in real time, but they do show statistics and configuration info about a feature or process. You can also use some of these commands to restart a process or execute a change in its operation.

Q50. Examine the partial output from two web filter debug commands; then answer the question below:

Based on the above outputs, which is the FortiGuard web filter category for the web site www.fgt99.com?

 Finance and banking

 General organization.

 Business.

 Information technology.

Q51. Examine the output of the ‘diagnose ips anomaly list’ command shown in the exhibit; then answer the question below.

Which IP addresses are included in the output of this command?

 Those whose traffic matches a DoS policy.

 Those whose traffic matches an IPS sensor.

 Those whose traffic exceeded a threshold of a matching DoS policy.

 Those whose traffic was detected as an anomaly by an IPS sensor.

Q52. Which real time debug should an administrator enable to troubleshoot RADIUS authentication problems?

 Diagnose authd console -log enable.

 Diagnose radius console -log enable.

 Diagnose debug application radius -1.

 Diagnose debug application fnbamd -1.

Q53. An administrator has configured a dial-up IPsec VPN with one phase 2, extended authentication (XAuth) and IKE mode configuration. The administrator has also enabled the IKE real time debug:
diagnose debug application ike-1
diagnose debug enable
In which order is each step and phase displayed in the debug output each time a new dial-up user is connecting to the VPN?

 Phase1; IKE mode configuration; XAuth; phase 2.

 Phase1; XAuth; IKE mode configuration; phase2.

 Phase1; XAuth; phase 2; IKE mode configuration.

 Phase1; IKE mode configuration; phase 2; XAuth.

https://help.fortinet.com/fos50hlp/54/Content/FortiOS/fortigate-ipsecvpn-54/IPsec_VPN_Concepts/IKE_Packet_Processing.htm

Q54. What is the purpose of an internal segmentation firewall (ISFW)?

 It inspects incoming traffic to protect services in the corporate DMZ.

 It is the first line of defense at the network perimeter.

 It splits the network into multiple security segments to minimize the impact of breaches.

 It is an all-in-one security appliance that is placed at remote sites to extend the enterprise network.

ISFW splits your network into multiple security segments. They serve as a breach containers from attacks that come from inside.

Q55. View the exhibit, which contains a partial routing table, and then answer the question below.

Assuming all the appropriate firewall policies are configured, which of the following pings will FortiGate route? (Choose two.)

 Source IP address 10.1.0.24, Destination IP address 10.72.3.20.

 Source IP address 10.72.3.27, Destination IP address 10.1.0.52.

 Source IP address 10.72.3.52, Destination IP address 10.1.0.254.

 Source IP address 10.73.9.10, Destination IP address 10.72.3.15.

Q56. Which the following events can trigger the election of a new primary unit in a HA cluster? (Choose two.)

 Primary unit stops sending HA heartbeat keepalives.

 The FortiGuard license for the primary unit is updated.

 One of the monitored interfaces in the primary unit is disconnected.

 A secondary unit is removed from the HA cluster.

 Loading …

How to study the Fortinet NSE7_EFQ-6.4: Fortinet NSE 7 – Enterprise Firewall 6.4 Exam

Authorized Training Centers (ATC) are available and can be located from this link. Fortinet ATCs provide a global network of training centers that deliver expert-level training in local languages, in more than a hundred countries. Further, Fortinet offers training in two different modes, public and private/ custom. Public training content is based on the standard NSE training curriculum. Customization is not possible for public training sessions. In private training, Fortinet instructors deliver the private training session onsite at the customer’s facility, or online through a virtual classroom application. There are several options for training delivery as well.

• Self-Paced E-Learning Training: Students can access previously recorded lessons, online videos, and quizzes on the NSE Institute portal to gain essential knowledge
• Onsite Instructor-Led Training: This is the traditional training that occurs in a classroom, where the instructor presents the material to the students in the same facility
• Online/Virtual Instructor-Led Training: This is an instructor-led training that is delivered live over the Internet. Students attend sessions using an online classroom application

So, the websites provide all the necessary training courses and candidates can take these courses to prepare for this exam. But no preparation is complete without the practice of exam dumps, hence NSE7 EFW-6.4 exam dumps are necessary to prepare for this exam. These NSE7 EFW-6.4 exam dumps pdf serve as practice questions and help candidates to understand what the exam environment will be like. The difficulty of any exam is a relative phenomenon. Also, it is quite tough to answer this without knowing your academic background and whether you have any prior exposure to financial markets. If you have prior exposure in the field of financial markets and follow the markets regularly, I think you will do just fine. However, if you are completely new to this field, you may have a hard time understanding a few concepts, but it is still manageable.

Difficulty in Writing Fortinet NSE7_EFQ-6.4: Fortinet NSE 7 – Enterprise Firewall 6.4 Exam

The difficulty of any exam is a relative phenomenon. Also, it is quite tough to answer this without knowing your academic background and whether you have any prior exposure to financial markets. If you have prior exposure in the field of financial markets and follow the markets regularly, I think you will do just fine. However, if you are completely new to this field, you may have a hard time understanding a few concepts, but it is still manageable.

You will be tested extensively only on the topics in the curriculum provided by NSE. It is more of a knowledge-based test rather than an application-based test. Make sure you do not miss any topic from the curriculum. There are no negative marks for incorrect answers in foundation modules. There are negative marks for incorrect answers in intermediate and advanced modules. Every exam can become a difficult one if not well prepared. Lots of study material for this exam is available online, at the official website, and in the form of NSE7 EFW-6.4 practice exam dumps. LatestCram provide the best quality exam dumps that are updated very often to keep them up to the mark. If students practice these exam dumps and take the NSE7 EFW-6.4 practice exams, they can surely overcome the exam difficulty and clear the exam with good grades. Below is a list of topics that students usually find difficult and challenging. Make sure you cover them in detail.

Download Real Fortinet NSE7_EFW-6.4 Exam Dumps Test Engine Exam Questions: https://www.latestcram.com/NSE7_EFW-6.4-exam-cram-questions.html