Free Cram & Latest Exams Dumps

Q11. You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

Q12. Whenever dissimilar metals must join, the most common practice is to

Q13. The most important factor resulting in improved job site safety is:

Q14. When performing tests for oil and grease using an ultra-violet light, the NACE Inspector should be aware that:

Q15. You are the NACE Inspector on a 5000 sq. ft. job where SSPC PA 2 has been specified.
Assuming all areas are in compliance, how many gauge readings and spot measurements are required?

Q16. Passivation can best be described as:

Q17. Polymerization is the process of:

Q18. Check abrasive blast pressure close to the

Q19. In the event of a conflict between the project specification and the coating manufactures’ product data sheet, the Inspector’s first course of action should be too:

Q20. If the specifier does not identify a restriction level in accordance with SSPC PA 2, the default restriction level is:

Q21. The primary difference between Non-Convertible vs. Convertible coatings is:

Q22. You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:

Q23. Which of these tests uses a syringe?

Q24. As a NACE Coating Inspector your responsibility with respect to safety is to:

Q25. If a Thermoset coating is heated it will:

Q26. Most industrial coatings are:

Q27. Surface profile describes:

Q28. ISO SA 3 is directly equivalent to:

Q29. Excess moisture during holiday testing can cause erroneous indications by creating a path across the surface of the coating to pinholes previously detected, or directly to the signal return connection.
This is often referred to as:

Q30. The Inspector should record the serial numbers of inspection instruments:

Q31. A NACE Coating Inspector is permitted to transport coating material when:

Q32. Excessive working of the surface with a power grinder can be detrimental because excessive burnishing

Q33. ISO ST 3 is described as: